We will show you how to turn off the DHCP Server so CUJO can work in DHCP mode.

You will need to change the DHCP Settings as set out below if you wish to connect your router to CUJO in "DHCP mode".

 

Connect CUJO:

At this point your CUJO has to be connected using just bottom CUJO port:

 


Activate DHCP mode using CUJO app:

Before turning off the DHCP server on your Router you have to activate it on CUJO (DHCP server will not be started until you reboot CUJO).

If you see the manual setup instructions page on the CUJO app, this means the DHCP server was activated on CUJO.


Disable DHCP on your Router:

Once you have connected CUJO and activated the DHCP mode on it, you can disable DHCP on your Router;

1) Login to your router and proceed to "Advanced Settings".

Link: http://192.168.1.254



2)When you will reach "Advanced settings" navigate to "My network". When you will try to access "My network" BT will prompt you with a request for you to provide "Admin Password" which can be found on the side of the router like in the image shown below.





3)After completing confirmation process proceed to "IPv4 configuration" and disable DHCP. Once you have disabled DHCP hit "Save" button.



4) Reboot CUJO (unplug power from CUJO and plug it back) and router


Once both devices reboot, CUJO will start protecting all your network devices connected to BT Home Hub router.