We will show you how to turn off the DHCP Server so CUJO can work in DHCP mode.
You will need to change the DHCP Settings as set out below if you wish to connect your router to CUJO in "DHCP mode".
At this point your CUJO has to be connected using just bottom CUJO port:
Activate DHCP mode using CUJO app:
Before turning off the DHCP server on your Router you have to activate it on CUJO (DHCP server will not be started until you reboot CUJO).
If you see the manual setup instructions page on the CUJO app, this means the DHCP server was activated on CUJO.
Disable DHCP on your Router:
Once you have connected CUJO and activated the DHCP mode on it, you can disable DHCP on your Router;
1) Login to your router and proceed to "Settings".
2)When you will try to access "Settings" you will be prompted to provide "Admin password" which can be found on the bottom of your router or on the side like shown in the image below. After completing confirmation process proceed to "Advanced Settings".
3)After completing confirmation process navigate to "Home Network"->"IP Addresses" and disable DHCP server on your router. Once the server is disabled hit apply the button.
4) Reboot CUJO (unplug power from CUJO and plug it back) and router
Once both devices reboot, CUJO will start protecting all your network devices connected to BT Home Hub router.