We will show you how to turn off the DHCP Server and change your Router's IP address so CUJO can work in DHCP mode.

You will need to change the DHCP Settings as set out below if you wish to connect your router to CUJO in "DHCP mode".


Connect CUJO:

At this point your CUJO has to be connected using just bottom CUJO port:


Activate DHCP mode using CUJO app:

Before turning off the DHCP server on your Router you have to activate it on CUJO (DHCP server will not be started until you reboot CUJO).

If you see the manual setup instructions page on the CUJO app, this means the DHCP server was activated on CUJO.


Turn OFF DHCP on your Router:

Once you have connected CUJO and activated the DHCP mode on it, you can turn off DHCP on your Router;

1) Login to your Ubee router using the link and credentials below;


Username: admin

Password is located on a sticker on your router


2) Navigate to "Basic" -> "DHCP" Disable the DHCP server by selecting "No" under "DHCP Server"

and save the settings by pressing the "Apply" button

3) Reboot CUJO (unplug power from CUJO and plug it back) and router (unplug power from router and plug it back)

Once both devices reboot, CUJO will start protecting all your network devices connected to Ubee router.