We will show you how to turn off the DHCP Server so CUJO can work in DHCP mode.

You will need to change the DHCP Settings as set out below if you wish to connect your router to CUJO in "DHCP mode".

 

Connect CUJO:

At this point your CUJO has to be connected using just bottom CUJO port:

 


Activate DHCP mode using CUJO app:

Before turning off the DHCP server on your Router you have to activate it on CUJO (DHCP server will not be started until you reboot CUJO).

If you see the manual setup instructions page on the CUJO app, this means the DHCP server was activated on CUJO.


 

Disable DHCP on your Router:

Once you have connected CUJO and activated the DHCP mode on it, you can disable DHCP on your Router;

1) Login to your router.

Link: http://192.168.1.254

Admin Password: (located on your router)


2) Navigate to IP Address configuration screen. 

Depending on the model of your router you may see one of these interfaces:

a) "Advanced Settings" -> "Home Network" -> "IP Addresses".

If you get asked, confirm that you want to "Continue to Advanced Settings"

- - - - - - - - - - - - - - - - - - - - OR - - - - - - - - - - - - - - - - - - - -

b) "Advanced Settings" -> "My network" -> "IPv4 configuration"


3) Disable DHCP server

Depending on the model of your router you may see one of these interfaces:

a) Once you are in IP configuration screen, select Enable: "No" under "DHCP Server".

And save settings by pressing "Apply" button.

- - - - - - - - - - - - - - - - - - - - OR - - - - - - - - - - - - - - - - - - - -

    b) Once you are in IP configuration screen, select Enable: "No" under "DHCP Server".

And save settings by pressing "Save" button.


4) Reboot CUJO (unplug power from CUJO and plug it back) and router


Once both devices reboot, CUJO will start protecting all your network devices connected to BT Home Hub router.