We will show you how to turn off the DHCP Server and change your Router's IP address so CUJO can work in DHCP mode.

You will need to change the DHCP Settings as set out below if you wish to connect your router to CUJO in "DHCP mode".

 

Connect CUJO:

At this point your CUJO has to be connected using just bottom CUJO port:

 


Activate DHCP mode using CUJO app:

Before turning off the DHCP server on your Router you have to activate it on CUJO (DHCP server will not be started until you reboot CUJO).

If you see the manual setup instructions page on the CUJO app, this means the DHCP server was activated on CUJO.


 

Disable DHCP on your Router:

Once you have connected CUJO and activated the DHCP mode on it, you can disable DHCP on your Router;

1) Sign into Google Fiber using the email and password you use for your Fiber account


2) In the settings pane (which appears on the right of the Network tab when you select your Network Box) select cujo device from device list. Then open "Advanced" settings




3) In the "Advanced" settings window change "Reserved IP" to ON and remember CUJO's IP (like 10.0.0.197 in the picture below). To save changes press "APPLY"


4) Go back to Router DHCP setup screen - select "Network" in the upper-left corner. (If you don’t see it, click the navigation menu to display the selection.). Then in the settings pane, click "Advanced".

Change "DHCP start address" and "DHCP end address" to your CUJO IP address (in example 10.0.0.197)

To save changes press "APPLY"


5) Reboot CUJO (unplug power from CUJO and plug it back) and router


Once both devices reboot, CUJO will start protecting all your network devices connected to Google Fiber router.